Juniper Websites: How do I log in to Juniper Websites?

Juniper Websites, Portal

Overview

This article explains how to sign in to your Juniper Websites CMS. There are two ways to do this, depending on how your school is set up to access Juniper Websites:

  • Using Portal (Login with JoinUp) - when you sign in, Portal opens from where you can access Juniper Websites.
  • Using Juniper Websites / CMS (legacy login) - you sign in directly to the CMS using your Juniper Websites email address and password. Only use this method if your school does not use Portal.

Prerequisites

Instructions

Follow the steps for the method that applies to your school.

  • Follow these steps to open Juniper Websites through Portal:
    1. In your web browser, enter the URL for your website followed by /admin, for example, www.yourwebsiteurl.co.uk/admin.

    2. When prompted, select Login with JoinUp:

    3. When prompted, from the Login page enter your JoinUp credentials:
      1. Enter the Email address for your account.
      2. Enter your Password. Select the eye icon () to view the password.
      3. Select Login.

    4. If you don't need to verify, Portal opens (see step 6). If verification is required, you are sent an email containing a Verification Code, and the Two-Factor Authentication (Required) page opens. Open the email you have received from Juniper Education and make a note of the code.

      If you cannot see the email, check your Spam / Junk folder. If it is not in those folders, select Resend Code.

    5. From Login with 2FA:
      1. Enter the Validation code from your email.
      2. Select Login.

    6. You are taken into the Portal home page. Select Juniper Websites from Your Juniper Products:

  • Follow these steps to sign in directly to Juniper Websites / CMS:
    1. In your web browser, enter the URL for your website followed by /admin, for example, www.yourwebsiteurl.co.uk/admin.
    2. When prompted, enter your Email address and Password.
    3. Select Login.
      Log in.gif

School-level terms and conditions

If you're an Account Owner logging in for the first time, and your school hasn't yet confirmed Juniper Education's establishment-level terms and conditions, you'll see a Terms and Conditions message before Portal is loaded:

  1. After reviewing the terms and conditions, to accept them, check I have read and accept Juniper Education Terms & Conditions, then select Confirm.
  2. To continue without accepting, select Remind me later. You'll be prompted again in 10 days, unless another Account Owner accepts them first.

Only Account Owners see this message. After an Account Owner accepts the terms and conditions, other Account Owners at your school won't be prompted again, as acceptance is at the establishment level.

Outcome

After signing in Juniper Websites loads:

Related information

Updated